What clutch puller are you guys using for the newer team primary with the roller bearing? I have a team puller for the 16 style primary but it doesnt seam right. I think it runs out of threads before contacting the crank.
clutch puller
- Thread starter Rixster
- Start date
I have been using the same one since 2013 and it works fine on my 2020. It’s one from slp.
Use the water method. 16 fits fine
I bought an M14 x 1.5 pitch bolt at Ace, think it was 100mm long, popped the clutch right off with hydraulic (water) method. No puller needed.
Similar threads
