2017 m8000 sno pro drive clutch cover bushing looks cracked?

[mtncat600]

HI ,2 SLEDS SNO PRO M8000 2017 DRIVE CLUTCH
COVER CENTER BUSHING LOOKS CRACKED
SAW PICS OF MORE THEY LOOK THAT WAY TOO ANYONE SEEN THIS ? THANKS

 

[sno*jet]

thats how they all are

 

[MountainCat1]

I installed a 911 clutch cover from Thunder Products on my '17 just for peace of mind.

 

[kanedog]

Can you post a pic?

 

[MountainCat1]

Can you post a pic?

My '17 Mountain Cat is currently at the shop getting an IceAge Elevate kit installed! It has BDX magnetic adjustable weights, clutching by Hubs Performance & the TP 911 cover. I can get a pic posted when I get it back.

 

[MountainCat1]

The idea behind the billet machined 911 clutch cover is to keep the primary sheaves parallel with a sleeve that supports the primary's shaft all the way out to the cover supported by a bronze bushing. The cover also allows you to adjust for belt to sheave clearance decreasing the distance the movable sheave travels upon engagement for a smoother take off.

 

[MountainCat1]

I also put the TP 911 clutch covers on my '1O M8 & '11 CFR8, hopefully to increase the longevity of those older AC clutches!

 

[sno*jet]

I think I would chew a hole clear through the side panel with the 911 cover. To the OP, the bushing should only be cracked on the side, not the actual sliding surface.