B
Hello All,
I have a 2004 Polaris Frontier touring 4 stroke liquid cooled sled with the 136" x 15" x 1" track and a 2.52 pitch track. It has front and rear heat exchangers and the heat exchanger tubes/lines run forward to aft inside and are shielded in the floorboards. I've finally decided to stud it for ice fishing and have a few questions. Can I stud this track without damaging the tunnel or rear heat exchanger? I purchased 108 Fast Trac 1.175" triple X series studs but I am wanting to be 100% sure I can stud this track without damaging anything. Do I need to install tunnel guards or wear strips and if so does anyone know what brand, length, etc. as I cannot locate a set anywhere on line. Any help or guidance would be great. Thank you
I have a 2004 Polaris Frontier touring 4 stroke liquid cooled sled with the 136" x 15" x 1" track and a 2.52 pitch track. It has front and rear heat exchangers and the heat exchanger tubes/lines run forward to aft inside and are shielded in the floorboards. I've finally decided to stud it for ice fishing and have a few questions. Can I stud this track without damaging the tunnel or rear heat exchanger? I purchased 108 Fast Trac 1.175" triple X series studs but I am wanting to be 100% sure I can stud this track without damaging anything. Do I need to install tunnel guards or wear strips and if so does anyone know what brand, length, etc. as I cannot locate a set anywhere on line. Any help or guidance would be great. Thank you