146 tunnel on 155?

[powdersnobb]

Long story short, cut my tunnel and welder made a mess of my 18 axys 800 155. Will a 146 tunnel fit? It looks a little different on the parts diagram. What about a 144?

Thanks.

 

[ullose272]

You got any pics? You could run a 5ft mtntk cooler instead if the stock cooler

Sent from my SM-G973U using Tapatalk

 

[powdersnobb]

Yeah that may be the next thing to do. Sucks. Pics are too big of files. Ill try to shrink.

 

[couch]

Used a couple of doo coolers on ours ...

Sent from my motorola edge plus using Tapatalk

 

[powdersnobb]

Used a couple of doo coolers on ours ...

Sent from my motorola edge plus using Tapatalk

What doo model?

 

[couch]

Damn d if I know ...just took measurements of what would fit ...pd $100 / cooler ...

Sent from my motorola edge plus using Tapatalk

 

[couch]

Fills up the entirety of the gap between the stock cooler extrusion ....
Added it after I had the tunnel cut completed so had to give if to the cooler extrusion. If I was doing it again I would install before putting the end in - it should fit in place of the tunnel top ..

Sent from my motorola edge plus using Tapatalk

 

[Funzy0798]

Fills up the entirety of the gap between the stock cooler extrusion ....
Added it after I had the tunnel cut completed so had to give if to the cooler extrusion. If I was doing it again I would install before putting the end in - it should fit in place of the tunnel top ..

Sent from my motorola edge plus using Tapatalk

Reviving old threads left and right... is this the long cooler or one a bit less than 3 feet? Is the mounting flange at the top flat side with the coolant ports or the finned side? BRP makes both styles depending on year

 

[couch]

These were out of the revs ...the cooler is bent but easily straightened in a press with a little patience

Sent from my motorola edge plus using Tapatalk