S
what are guys running ? tki recommends 2.33 ratio for 153 3" in a little Leary gearing up that much from the stock 2.63. whats guys running for gear ratio ?
2016 m8000 belt drive gear ratio
- Thread starter Sledneck_1987
- Start date
S
i ride 5000- 8000ft. sled makes about 25hp more than stock 7 tooth drivers.
I would go with 2.25 or 2.33. I ran 2.17 with my bigbore at 10K
^^^^^this
T
I have 2.33 on a 153 2.6 track. Full jaws setup at sea level.
Same elevations as you, Im running 2.25 now, stock engine, 7 tooth drivers, 153 track, and I'm 250 geared up.
I tried 2.42 right off the bat but went up after a few rides.
S
i ended up ordering a mvm kit in 2.42ratio. hope it will work good.
M
I have a 16' M6000 Ctec2 153 and 16' M8000 162
Both have 7t driver and 3' Powerclaw track.
I tried it both on stock gearing when i buying it.
I gearing up the 8000 first at 20/49 (2.45) and better! I gearing up again to 21/49 (2.33) and now he pulling hard.
I gearing up the 600Ctec2 at 20/50 (2.50) and he feel way better i too, i will try 20/49 (2.45) on it this year.
Is there someone who knows if 21/48(2.28) can work on chaincase
Both have 7t driver and 3' Powerclaw track.
I tried it both on stock gearing when i buying it.
I gearing up the 8000 first at 20/49 (2.45) and better! I gearing up again to 21/49 (2.33) and now he pulling hard.
I gearing up the 600Ctec2 at 20/50 (2.50) and he feel way better i too, i will try 20/49 (2.45) on it this year.
Is there someone who knows if 21/48(2.28) can work on chaincase
Ran 2.42 for a couple rides last year and Tom has me switch to 2.33 was significantly better. Definitely do the 2.33 or maybe even 2.25. With 7 tooth drivers these things are geared way way too low. Nice to be able to at least hit 70
Similar threads
