It depends on how much weight you are removing from the pin. If the pins are loaded 1/2 full or 1/4 full. It all has different effects on the RPM range.
Losing RPM... and I want it back!
- Thread starter backcountryislife
- Start date
It depends on how much weight you are removing from the pin. If the pins are loaded 1/2 full or 1/4 full. It all has different effects on the RPM range.
From what I understood the pin should be hollow here, but not sure how they come from BRP for comparison.
It probably has a single 1/2"-ish long set screw which is about 2g. Good for 200rpm and 1-2 clicker positions (typical)
