This chassis is built off a 2005 900 RMK. The sled has total of 862 miles on it with appox 500 miles since I did the 1140.I am selling this for a customer. Some of the features are as followed.
Carls Cycle 1140 engine kit with 32mm crank and drive clutch. When motor was built I started with a new crankcase and crankshaft.
Crank Shop twin pipes with stingers.
Carls Cycle custom motor mount setup
VanAmburg Boondocker 174" Tunnel
Camoplast Challenger Extreme 174" three inch pitch track
Avid antiratchet drivers
Holz rear suspention with Fox floats
Mountain Machines rear axel with 9" billet wheels
Holz front suspension with Fox floats and Holz spindles
Mitch's Marine carbon fibre hood
Timbersled steering post and Timbersled rider select delete
Simmons skis
2Cool vents and SLP vents
Fly bars and Fly riser
The sled requires a 50/50 race/pump gas
Jack wont say what horespower is but is easily over 200.
Asking $9000.00
Carls Cycle 1140 engine kit with 32mm crank and drive clutch. When motor was built I started with a new crankcase and crankshaft.
Crank Shop twin pipes with stingers.
Carls Cycle custom motor mount setup
VanAmburg Boondocker 174" Tunnel
Camoplast Challenger Extreme 174" three inch pitch track
Avid antiratchet drivers
Holz rear suspention with Fox floats
Mountain Machines rear axel with 9" billet wheels
Holz front suspension with Fox floats and Holz spindles
Mitch's Marine carbon fibre hood
Timbersled steering post and Timbersled rider select delete
Simmons skis
2Cool vents and SLP vents
Fly bars and Fly riser
The sled requires a 50/50 race/pump gas
Jack wont say what horespower is but is easily over 200.
Asking $9000.00
Last edited:
