Snoscoot motor mods, Blew the old one

Tahoe timberman · Mar 2, 2016

Main rod bearing sent a message to the piston and the motor needs a build. Its an electric start machine and I will be doing a long track conversion this summer so I'll build the motor at the same time. So what have you guys done to these little 80's to make that track speed up a bit. Or is there a replacement top end or complete motor out there?? Just something to keep a couple of agro six year olds happy.

utah340six · Mar 7, 2016

good luck piston is it own with a 10mm wrist pin
drivers a hard to come buy.
I have a test set built buy avid

haymaker11 · Mar 14, 2016

I have engine parts for you if you need.

madmax · May 12, 2016

Lindsay machine in Salt Lake City makes a nice little big bore ripper for it.

leafstodd · May 12, 2016

I'm working on machining a small production run of 1" hex axle / driveshafts for the Scoots. The 1" hex axle / driveshaft will open up a full variety of readily available drivers and pitch to match the track choice.

utah340six · Jun 5, 2016

Drivers

Check out avid drivers ronnie is making them now.
I am curently finishing up first track conversion with his new drivers

JamesS · Aug 1, 2016

Make sure the stock motor is running as well as it can first, then look into clutching and if a person still wants more power you can always have the cylinder ported and polished, the head shaved, add a bigger carb, reeds, pipe, etc.

haymaker11 · Aug 6, 2016

utah340six said:
good luck piston is it own with a 10mm wrist pin
drivers a hard to come buy.
I have a test set built buy avid

I have a few unused pistons still n the box. Standard size and 2nd oversize

Search

Snoscoot motor mods, Blew the old one

Tahoe timberman

Free Member

utah340six

Member

haymaker11

Free Member

madmax

Well-known member

leafstodd

Member

utah340six

Member

JamesS

Free Member

haymaker11

Free Member

Similar threads