#1
|
|||||
|
|||||
![]()
Thoughts and comments on each. They all seem to claim about the same HP gain, and all around that 500 to 700 dollar range.
Ace |
#2
|
|||||
|
|||||
![]()
Jaws pipe is the only one that I know that has been tested side by side with a stocker and shown gains in the field.
|
The Following 2 Users Say Thank You to ak For This Useful Post: | ||
sledhead_24_7 (12-05-2018), wyox (01-07-2019) |
#3
|
|||||
|
|||||
![]()
I went the Jaws pipe combo because of the dynotech numbers, the pipe is clad with an aluminum heat shield similar to the stock pipe minus the insulation; won't know for sure until I have the pipe next week?
At about $1000 cdn. it's about $100/Hp or $100 per lb.for weight saved. If it makes more Hp at elevation bonus. The Powder Freak Head will make some Hp but not tested by an independent third party? The combination of the Jaws pipe combo and the Powder Freak Head will will not play well together because both increase Hp by increasing compression? The Silver reflash I am unfamiliar with, no comment. For my money a 10 Hp bolt on without any programmers or high octane fuel is the way to go. I tend to follow the KISS principle. Jmo. |
The Following 4 Users Say Thank You to Andystoy For This Useful Post: | ||
#4
|
|||||
|
|||||
![]()
673 before taxes and ride for Jaws Kit.
487 before taxes and ride for Powder Freaks Head. 350 Re Flash only, or 600 with cable to do at home. Ace Last edited by Ace Freely; 12-05-2018 at 04:07 PM. |
#5
|
|||||
|
|||||
![]()
Silber flash can probably get @ timing map instead of a timing key?
So I wonder what a timing key would cost? A little bump in timing might make a noticeable difference? Sent from my iPhone using Tapatalk |
#6
|
|||||
|
|||||
![]()
Im running npp full pipe with powder freaks head and it rips compare to stock. The powder freaks head was tested on 2 different dynos averaged 9hp peak and 15hp in the mid range. Huge gains over stock compared to just a pipe. Also need to clutch accordingly
|
The Following 2 Users Say Thank You to Zx For This Useful Post: | ||
sledhead_24_7 (12-05-2018), wyox (01-07-2019) |
#8
|
|||||
|
|||||
![]()
I talked with Duayne today, owner of Power Freaks. Nice guy, VERY knowledgeable. He has 2 independent dynos showing 15 hp in the mid range. When PV open, look out!
Had quite a few on the snow last year, with 0 issues. Ace |
#9
|
|||||
|
|||||
![]() Quote:
That’s what I’m talking about!! $22.00 for 5-10hp? Sent from my iPhone using Tapatalk |
#10
|
|||||
|
|||||
![]()
Any new info?
Ace |
#11
|
|||||
|
|||||
![]() Click Here to Register |
#12
|
|||||
|
|||||
![]() Click Here to Register |
#13
|
|||||
|
|||||
![]() Click Here to Register |
The Following 2 Users Say Thank You to worx53 For This Useful Post: | ||
ryanjeri (12-26-2018), sledhead_24_7 (12-25-2018) |
#14
|
|||||
|
|||||
![]() Click Here to Register |
#15
|
|||||
|
|||||
![]() Click Here to Register |
#16
|
|||||
|
|||||
![]() Click Here to Register |
#17
|
|||||
|
|||||
![]() Click Here to Register |
#18
|
|||||
|
|||||
![]() Click Here to Register |
#19
|
|||||
|
|||||
![]() Click Here to Register |
#20
|
|||||
|
|||||
![]() Click Here to Register |
#21
|
|||||
|
|||||
![]() Click Here to Register |
The Following 2 Users Say Thank You to Old mtn. man For This Useful Post: | ||
Ace Freely (01-13-2019), ChickenMan (01-13-2019) |
![]() |
Bookmarks |
«
Previous Thread
|
Next Thread
»
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Thread — Best bang for my buck??? | Thread Starter — JAW | Forum — Trucks and Trailers | Replies — 17 | Last Post — 11-16-2012 08:01 AM |
Thread — is a RKT head a good bang for the buck on a M7 | Thread Starter — Einar74 | Forum — Arctic Cat: M Series | Replies — 12 | Last Post — 12-19-2011 08:51 AM |
Thread — PCV or Pipe/Can best bang for the buck? | Thread Starter — Adobe-Al | Forum — Polaris: IQ | Replies — 7 | Last Post — 01-31-2010 09:30 AM |
Thread — Best Bang for Your Buck | Thread Starter — Customization | Forum — Performance/Modified | Replies — 17 | Last Post — 10-22-2009 08:37 PM |
Thread — bang for buck | Thread Starter — zttam | Forum — Performance/Modified | Replies — 0 | Last Post — 10-19-2008 08:06 PM |
All times are GMT -6. The time now is 03:59 PM.