Just wondering if you are able to set your tps with the pc v and if you can how?
Checking TPS with Pc V?
- Thread starter PR Performance
- Start date
You cannot set your tps with the PCV. It only syncronizes the tps with the setting on the PCV.
C
if your going to run your pcv all the time
you can check and set your tps to run at 100% throttle
have your sled running and up on a stand and hold it down for like 3-4 seconds and look to see how much throttle your getting at WOT and youll see if you need to adjust it or not
you can check and set your tps to run at 100% throttle
have your sled running and up on a stand and hold it down for like 3-4 seconds and look to see how much throttle your getting at WOT and youll see if you need to adjust it or not
M
Really?
When you power up you PCV initially (with a laptop or computer) the TPS function pops up first, if it doesn't its easy to find in the menue at the top of the screen. You can see what the voltage is on the screen without the sled running if you power up through the 12volt pulg in the wiring harness just above your clutch gaurd above your primary clutch. You can also see what the W.O. voltage is when you put the gas to the bar. You have to enter these values into the PCV so it knows what the min and max values are and adjusts the curve accordingly. If your TPS is out of calibration or you enter some bogus values bad things will happen. You can use the PCV to help you acheive the correct TPS setting but it will not do it for you. The minimum voltage is just as important and the 100% (wide open) voltage.
When you power up you PCV initially (with a laptop or computer) the TPS function pops up first, if it doesn't its easy to find in the menue at the top of the screen. You can see what the voltage is on the screen without the sled running if you power up through the 12volt pulg in the wiring harness just above your clutch gaurd above your primary clutch. You can also see what the W.O. voltage is when you put the gas to the bar. You have to enter these values into the PCV so it knows what the min and max values are and adjusts the curve accordingly. If your TPS is out of calibration or you enter some bogus values bad things will happen. You can use the PCV to help you acheive the correct TPS setting but it will not do it for you. The minimum voltage is just as important and the 100% (wide open) voltage.
Last edited:
you can use the pcv to check the idle setting of the tps. won't do anything about the baseline setting.
