C
i bent my tunnel right behind the clutch side driver bearing mount has any one herd of a brace u can buy for that area or any ideas
bent bulk head / tunnel
- Thread starter colbypetersen
- Start date
Van Amburg makes the supports you need. I kinked one on the mag side on a 14 pro, take everything loose dolly it out the best you can and apply their braces and your good to go as long as the bulkhead is not bent.
X2 on the recommendation above.
B&M Fabrication in MN also makes the supports you need.
B&M Fabrication in MN also makes the supports you need.