• Don't miss out on all the fun! Register on our forums to post and have added features! Membership levels include a FREE membership tier.

Video For Tps Setting 2005 900 and 2006 700/900 CFi

Thread Rating
4.00 star(s)
B

BIGGDAWG

Well-known member
Jul 6, 2001
1,860
676
113
53
Waverly, Iowa
i went through one tps sensor and one tps harness, caused me a lot of headaches. the video helped when i set the new one up. i would recommend replacing the harness connector when doing the tp.
 
E

Ex-Member

ACCOUNT CLOSED
Mar 14, 2007
45,084
1,681
113
Wires on mine were bad when I fired up my sled again. Connector and pins are fine, wires are cheap junk. Pulled new wires and used the existing pins/connector, real easy to do.
 

mountainhorse

Well-known member
Lifetime Membership
Premium Member
Dec 12, 2005
18,606
11,814
113
West Coast
www.laketahoeconcours.com
900 rmk's...but this is a calibration setting... like as in tune up....

I've seen some sleds that have the baseline TPS setting pretty bad, This video does not apply to the small-block CFi motors
 
Last edited:
E

Ex-Member

ACCOUNT CLOSED
Mar 14, 2007
45,084
1,681
113
Can infer the voltage from a resistance reading. Make sure there's no skips or jumps across the scale on both sides.

The TPS sensor is just a potentiometer.... not terribly complicated devices.
 

POLZIN

Well-known member
Premium Member
Nov 26, 2007
4,092
1,546
113
50
Farmington NM
Can a consumer buy the TPS equipment from the video or do most peeps generally fabricate there own ! I know I have seen plans for one here on the site.I am going to put new carb boots and FBFs t-cable on and would like to do this will I am at it .I have always had a fouling problem as well and hope maybe this could solve that issue as well .
 
Premium Features