thanks bd i got the pc V on my 06 and it is working but know i am fighting with the wide band 2. I cant get it to read the rpm, or afr, or lambda. know on the laptop it shows rpm from the pc v:light:
did you install the jumper plug in the pcv i will look for the instructions.but it won't work with out it. it is called the can termination plug check out the instructions here.
http://www.powercommander.com/downloads/UserGuides/AT200/AT-200.pdf
excerpt from the instructions:
Install the Auto tune module near the PCV.
• Connect the Auto tune module to the PCV using the supplied CAN cable. It does not matter what port the cable is connected to.
•
Install the CAN termination plug into the open port of the Autotune module.This is the small BLACK plastic connector in the kit.
• Connect the O2 sensor cable to the O2 sensor and route the cable to the Auto tune module ensuring the cable will not get pinched or damaged by the
exhaust. The cable can be trimmed shorter if desired.
• Connect the O2 sensor cable to the Auto Module.
• Connect the BLACK wire from the AT200 to a good chassis ground using either one of the supplied Positaps or ring lug. The negative side of the battery
is a good location.
• Connect the RED wire of the AT200 to a switched 12v source using the supplied posi-tap.The power for the tail light is a good location.
Most PCV install guides will tell you the wire color for this location.
• Block or disable the clean air injection system if applicable (see tech tips).