B
how much weight should i have in 8bu or total weight of each for 10 to 15 lbs boost
primary weights
- Thread starter BOOSTIN-BAYOU
- Start date
I have 62g in each arm with supertips and I run right at 10lbs of boost.
Sent from my Commando
Sent from my Commando
If you have the 8BU-17605-00 at 48.7 grams add two 17.2mm rivets (4.5g) each ,fully loaded 57.7 grams. At your riding elevation you should be turning 8800 to 9000 rpm.From there you can fine tune with spring rate, heavier spring rate acts like lighter weight yielding higher rpm, where lighter spring weight brings rpm down.Remember one change at a time.
Jeff
S
8bu's
I used to run 8bu's fully loaded with .5g washers squeezed inbehind both rivits and that was good to 12-13psi. This year I got the mpi brass ones giving me 65ish grams total mass. Ran 17psi in vale pulling 8600.. Works good.
I run
14.5mm rollers
Bwb primary
Ac purple sec spring
45deg straight
If your close to this you should have no problems getting to the nose bleed section.
I used to run 8bu's fully loaded with .5g washers squeezed inbehind both rivits and that was good to 12-13psi. This year I got the mpi brass ones giving me 65ish grams total mass. Ran 17psi in vale pulling 8600.. Works good.
I run
14.5mm rollers
Bwb primary
Ac purple sec spring
45deg straight
If your close to this you should have no problems getting to the nose bleed section.
Similar threads
