Im trying to be ready for winter before winter hits. I purchased this Painless Cirkit deal so I can wire in power for my GPS, Headlight and handwarmers. My question is where can I tap into ignition on power to activate the relay.
Ignition power on 2015 KTM 450 XCF
- Thread starter philsummers21
- Start date
R
Right under the seat there is a molex that is either 3x3 or 4x4... I'm trying to imagine it now. Nick tapped into power that only works when the bike is running to power my nitrous solenoid. I'll take a picture of it when I get home.
R
Found it in an old message. It's the Orange wire. Pull the rubber plug out of the bottom and you can plug right into the connector on the underside.
you can just t-tap into the wire, If you want to get fancy with wiring I can point you at pins and seals that you can put into the cap plug on the end of it.
What pin is it. I should have the pins and seals at work. Thanks guys
Last edited:
As in what connector position or pin style?
http://www.bmotorsports.com/shop/product_info.php/cPath/109_110/products_id/686
99% sure these are the ones, i have a local supplier that builds custom wiring so I just show them what I need and get them.
http://www.bmotorsports.com/shop/product_info.php/cPath/109_110/products_id/686
99% sure these are the ones, i have a local supplier that builds custom wiring so I just show them what I need and get them.
Perfect. I should have them then.
Similar threads
