E
Putting together a DIY build. Where should I put my EGT thermocouple? I was thinking just before the turbine after the pipe. What is the best location for tuning?
Carb Turbo - Where to measure EGT
- Thread starter Eltigre6000
- Start date
It needs to be as close to the pistons as possible for an accurate reading, so in the y pipe as close as possible.
E
Thanks guys! Will start with EGT in each runner of y pipe
E
I think I have the EGT plan figured out so now onto AFR. Where is the best place to weld the bung? Collector in y-pipe? Post expansion chamber, pre-turbine, post turbine, etc. I'm thinking it may not matter as long as it can get a good signal. Post turbine would have the least impact on performance but with the wastegate it may be difficult to get a great signal.
