Anyone know if the water trick for clutch removal will work on the G4?
Thanks
Thanks
Water trick on G4
- Thread starter Skidooguy
- Start date
I have done it on my 850 but I went and bought
A metric bolt the same threads so there was more threads to hold the Teflon tape.
Sent from my iPhone using Tapatalk
A metric bolt the same threads so there was more threads to hold the Teflon tape.
Sent from my iPhone using Tapatalk
yes
1Remove clutch bolt.
2Lay sled on side.
3Put Teflon tape on clutch bolt threads to hold back water
4Fill clutch bolt hole with water
5Screw in clutch bolt fast and the pressurized water will pop off clutch bolt.
6repeat step 4 & 5 until successful
I
Re
Yes it works, but I had to use thicker Teflon tape for it to work. Light yellow tape for gas pipes did the trick.
Yes it works, but I had to use thicker Teflon tape for it to work. Light yellow tape for gas pipes did the trick.
Make sure to use good Teflon tape and not the cheap stuff, ask me how I know.
There’s a few YouTube videos online about doing the water trick. I’ve used (or tried to) use a clutch puller on my primary and the scared the heck out of me, with the amount of force I had to apply.
Water trick worked quite easy and was much much less aggressive.
There’s a few YouTube videos online about doing the water trick. I’ve used (or tried to) use a clutch puller on my primary and the scared the heck out of me, with the amount of force I had to apply.
Water trick worked quite easy and was much much less aggressive.
Thanks everyone. Just got the new sled home and ready to do some clutch work.
Similar threads
