So I'm looking for a little help or at least maybe a direction to go with this.
I've got a IQR that has been fully trail converted with a 600 HO and PERC.
I purchased the sled as is and did not do the conversion myself, so that's why I'm looking for a little assistance.
Basically I went and had to re-jet and once I got everything back together I took it for a rip. Sled runs good but......after you get on it the tach goes all goofy and the Digatron EGT gauge goes goofy too.
The tach works at idle while you are parked but as soon as you take off it drops from 5 thousand RPM and bounces backwards and then goes to zero.
The dual EGT gauge also works at idle but when its under load, the gauge hits the warning lights then goes blank. So in a sense it is acting like the tach???
Also the PERC is now not working ???? This all happened after I re-jetted, so I'm guessing I pinched or may have pulled a wire, possibly a ground wire of some kind?????
I didn't have a chance to open it back up yet, but I was hoping for maybe a little tip or advice, so I'm not chasing dead ends!!
Big thanks to anyone!!!!
I've got a IQR that has been fully trail converted with a 600 HO and PERC.
I purchased the sled as is and did not do the conversion myself, so that's why I'm looking for a little assistance.
Basically I went and had to re-jet and once I got everything back together I took it for a rip. Sled runs good but......after you get on it the tach goes all goofy and the Digatron EGT gauge goes goofy too.
The tach works at idle while you are parked but as soon as you take off it drops from 5 thousand RPM and bounces backwards and then goes to zero.
The dual EGT gauge also works at idle but when its under load, the gauge hits the warning lights then goes blank. So in a sense it is acting like the tach???
Also the PERC is now not working ???? This all happened after I re-jetted, so I'm guessing I pinched or may have pulled a wire, possibly a ground wire of some kind?????
I didn't have a chance to open it back up yet, but I was hoping for maybe a little tip or advice, so I'm not chasing dead ends!!
Big thanks to anyone!!!!