upgrading 09 d8

miner700 · Nov 27, 2010

I am putting a slp y-pipe, pipe, and can, hi flow intake, new blue/pink primary,and slp recommended mtx 68 weights. run a pink exhaust spring, cant remember the helix but not stock. my new belt has a side clearance of .028 will i have to reshim the primary? How will this run, also have a pcv that i will program with slps recommended map

Nelson · Nov 27, 2010

Yes, your belt to sheave side clearance should be .010-.020

What secondary are you using? TSS98, TSS04, Tied?

I ran the Black/Purple driven spring in my 08 D8 163, 3 delrin washers, 62-42E.36 Helix in my TSS04 with 2 .070 thick spring washers reducing my initial angle from .46 to .36

The sled ripped

If you haven't looked into it you might want to check out Ron's modified weights for the primary.

miner700 · Nov 27, 2010

running a tss-04, rons 61 weights, 3 delrins,60-40-.36 helix

Nelson · Nov 29, 2010

I wouldn't worry about reshimming your primary until after installing the MTX weights since they have a higher heel profile which might tighten up your belt to sheave clearance. Goodluck with your set up, I've had a lot of luck running the MTX weights in my sleds.

miner700 · Nov 29, 2010

thanks

very anxious to try this setup,thanks for the input

Search

upgrading 09 d8

miner700

Free Member

Nelson

Well-known member

miner700

Free Member

Nelson

Well-known member

miner700

Free Member

Similar threads