AARGH, broken roller in my secondary.

It needs yo be fixed, wont work very good an the other will likely break and take out the helix.
Great timing huh? That sucks!
Hopefully you can find rollers, how far from Baker city? I think the dealer there can fix you up.

I will try to earn your buisiness one more time!

cliffs saw and cycle is an hour away from you and show they have 2 on our dealer locator their # is 541-523-2412
Remove the clips before pulling the studs and you can save them!



54.5 mi, 1 hour 8 mins OR-86 W
Driving directions to Baker City, OR 3D2D

Halfway, OR

1. Head east on W Bell St toward Pine St
0.1 mi
2. Slight right onto N Main St
0.7 mi
3. Continue onto Halfway Spur
0.8 mi
4. Slight right onto OR-86 W
50.8 mi
5. Keep right at the fork
1.1 mi
6. Turn right onto Campbell St
0.4 mi
7. Turn left onto Main St
0.4 mi
8. Turn right onto Valley Ave
0.2 mi
9. Turn left onto 4th St
161 ft

Baker City, OR
hope that helps!

the parts # is
roller 417127016 they have 2
clip 414753500 they have 1
stud 417127259 they show none
the stud supercedes 3 time they don't show any but if theyrollers broke you can do it without them..
good luck I hope it works out for you!

jacmmaxwell said:

Blew a roller on my secondary, 500 miles from home and the local dealer does not have any.

I know it's not good but.. has anyone run it like this? I run the risk of killing my Roosterbuilt helix if it goes but what else?

If anyone knows of anyone with a roller in the halfway oregon area, let me know.

Click to expand...

I lost both my secondary rollers on a ride with my 08. Scratched up the ramps on the helix
But not the ones the rollers roll on, the pins did not make contact with the them. New rollers and ran ran that helix for 1500 hundred miles till I sold the sled. It did upshift and backshift pretty bad without rollers. Lol