T
I have some parts from my 2001 Arctic Mountain cat 800. The latest engine I put in was a 2002 or newer 800 with the Cutler 900 big bore kit. The domes have "HC" and 3.62 stamped in them. I think these are the high compression domes.
I have the Cutler 900 jugs with cylinder caps,
stock 800 jugs and caps,
thermostat housing with dual threaded holes for running double temp sensors,
2001 clutch with new spider last year. No weights or springs.
The lower end crank case halves from the 2001 800cc. Haven't separated the case halves yet so crank and pistons are still in. Will remove for shipping.
2001 crank good for core or rebuild (spun rod bearing)due to antifreeze in crank case.
Misc. front end steering part. I think control arms and steering post. Possibly others not sure.
Motor mounts
Stator
No carbs or reeds.
Most of the above parts other than the big bore kit are from a 2001 mountain cat carbureted 800cc
I'M HAVING TROUBLE POSTING PICS ON HERE. IF INTERESTED PLEASE PM ME WITH YOUR EMAIL AND I CAN SEND YOU PICS.
I have the Cutler 900 jugs with cylinder caps,
stock 800 jugs and caps,
thermostat housing with dual threaded holes for running double temp sensors,
2001 clutch with new spider last year. No weights or springs.
The lower end crank case halves from the 2001 800cc. Haven't separated the case halves yet so crank and pistons are still in. Will remove for shipping.
2001 crank good for core or rebuild (spun rod bearing)due to antifreeze in crank case.
Misc. front end steering part. I think control arms and steering post. Possibly others not sure.
Motor mounts
Stator
No carbs or reeds.
Most of the above parts other than the big bore kit are from a 2001 mountain cat carbureted 800cc
I'M HAVING TROUBLE POSTING PICS ON HERE. IF INTERESTED PLEASE PM ME WITH YOUR EMAIL AND I CAN SEND YOU PICS.
Last edited:
