I have a 2013 SBA with 4800 miles and was removing the primary with a clutch puller when the PTO end of the crank snapped with very little force on the puller.
A buddy of mine was looking at it and thought the crank must have already been snapped from torque force due to the rings on the break.
I have never broken a belt on the sled and when I rebuilt the top end last season the crank bearings seemed to be in good condition. I also have a slp torque arm installed.
I am hoping to do a relatively cheap and quick fix so I don’t lose to much of the season. I saw that there are used cranks on eBay would they be worth getting or should I just bite the bullet and get new crank? Also is there any other problems I should look out for that would have caused the crank to break so it doesn’t happen again?
Any info from the experts on here would be much appreciated!
Sent from my iPhone using Tapatalk
A buddy of mine was looking at it and thought the crank must have already been snapped from torque force due to the rings on the break.
I have never broken a belt on the sled and when I rebuilt the top end last season the crank bearings seemed to be in good condition. I also have a slp torque arm installed.
I am hoping to do a relatively cheap and quick fix so I don’t lose to much of the season. I saw that there are used cranks on eBay would they be worth getting or should I just bite the bullet and get new crank? Also is there any other problems I should look out for that would have caused the crank to break so it doesn’t happen again?
Any info from the experts on here would be much appreciated!
Sent from my iPhone using Tapatalk