I hate to do this, but my eyes are going crossed searching.
I remember reading a thread (can't remember how I found it then) about a way to add a switch to an XD-16 to extend the life on the O2 sensor.
I can't remember if it was a way to switch it off until the sled was at operating temperature or if it was a way to pre-heat the sensor to prevent fouling. I wouldn't think a 4-stroke would need to be pre-heated, but I'm not for sure.
Any help is appreciated either directly or maybe a link to the holy-grail white unicorn of a thread that I can't find anymore. :face-icon-small-con
I remember reading a thread (can't remember how I found it then) about a way to add a switch to an XD-16 to extend the life on the O2 sensor.
I can't remember if it was a way to switch it off until the sled was at operating temperature or if it was a way to pre-heat the sensor to prevent fouling. I wouldn't think a 4-stroke would need to be pre-heated, but I'm not for sure.
Any help is appreciated either directly or maybe a link to the holy-grail white unicorn of a thread that I can't find anymore. :face-icon-small-con
