09 ramps with Joe's Kit??

You can go to a 413 or 415 and run clicker 1 or 2 where you're at now with that pin weight. I find these ramps a lot more "buzzy" than the 441's and don't get the top end out of them....but for big elevation they might be OK. Why not go to a 160/380 spring in the primary and leave the 441's alone?

I believe Joe sends a 160/350 spring...or his newest kits are 175/355 (I think). I would go to a 160/380 before trying a different ramp....waaay cheaper too.

09 Blue Ski-Doo said:

We have 09 163 x's running Joes clutch kit, we like them but not quite getting all we want yet. Is there a better ramp out there for just a little harder finish than the stock 09 ramp? We don't want to drop any lower than the 15.3 grams of pin weight and sitting on click 4 already(where we want to be) we're at 6500, but heading to cooke at 10,000. Help anyone?

Click to expand...

Hello. 15.3g up to about 8000 feet. 14.5g at 8500+ should be good.
A note - After a year of trying to get this spring made, I finally got them in. Tested in December and been sending them out in all the xp kits now with 441 ramps whatever the sled may be even if its an 07xrs and clutch using 441.

Spring is a 175/360.
Compared to the 160/350 this new Violet/white stripe offers about 10 lbs more force at 40mph track speed....which is then just good. :face-icon-small-hap

I would like the opportunity to help you extract more of what you want out of the kit, if you have questions then there is more potential that I can help out with. Please email me at info(at)mxzx-revzone.com

or

give me a shout 807.346.9701

or

message me here so I can call you and can get you this stuff before you hit cooke - and so I can go over what more you like to see out of the kit.

thanks
Joey

THANKS
Joey