• Don't miss out on all the fun! Register on our forums to post and have added features! Membership levels include a FREE membership tier.

2003 Summit 800 151

S
Feb 20, 2008
387
41
28
it raised the back up about an inch which should help with something;)ahah as far as the bit i didnt have one the rite size so i had to ream it.
 
M
Nov 12, 2008
233
17
18
Flathead
Yeah I was also thinkin of drilling a hole
furthur down but scored a way nice set of aluminum drop brackets..
however I think theyre a little more of a pain in the a$$ than I thought

Im thinking since I have to drill new holes to mount
these up I need to get that track out from underneath
my tunnel a bit more.. that way I can take easier measurements.

Anyone put whole new brackets like this in?
Id assume measuring from the driveshaft
back to the stock drop bracket bolt, as that distance
should not change, and from the top inside of the
tunnel down to that same bolt with adding whatever lift I wanted???:eek: Right?
 
S
Feb 20, 2008
387
41
28
Yeah I was also thinkin of drilling a hole
furthur down but scored a way nice set of aluminum drop brackets..
however I think theyre a little more of a pain in the a$$ than I thought

Im thinking since I have to drill new holes to mount
these up I need to get that track out from underneath
my tunnel a bit more.. that way I can take easier measurements.

Anyone put whole new brackets like this in?
Id assume measuring from the driveshaft
back to the stock drop bracket bolt, as that distance
should not change, and from the top inside of the
tunnel down to that same bolt with adding whatever lift I wanted???:eek: Right?

just take off the old bracket. bolt the new drop bracket to your suspension lay it on the tunnel drill and rivit:D
 
M
Nov 12, 2008
233
17
18
Flathead
Finished it all up lastnight:D
It really wasnt too bad with help from a couple buddies,
to hold the tape measures while I marked the holes

^ ^ Couldnt just lay the tunnel down on the brackets..ha
I ended up measuring from the driveshaft back to the stock bolt holes.

All in all, added 2 5/16" lift which didnt affect the approach angle too much,
or any other susp. parts.. And it looks pretty siick now ;)
 
Premium Features