N
have an 08 XP with cracked bulkhead framework. had anyonr successfully welded/gusseted these?
thanks
thanks
08 XP cracked bulkhead... weld?
- Thread starter n16ht5
- Start date
N
One of our Summits broke there also. I just put several structural rivets through it and its going on the 3rd year like that.
N
I mig welded it, good penetration and no boils. Got pistons out waiting for parts.
T
Personally I'd replace it or just ride it.
My one sled has been like that for over 6 years.
Also I've been told is casted parts don't weld well.
My one sled has been like that for over 6 years.
Also I've been told is casted parts don't weld well.
P
Replace. Weld ? Will just crack again.
I've welded cast aluminum quite a bit.
It usually cracks again.
Where that is and since its an 08 xp i'd just add a strip of aluminum and a couple cherry max rivets. Then run it.
It usually cracks again.
Where that is and since its an 08 xp i'd just add a strip of aluminum and a couple cherry max rivets. Then run it.
P
Same thing happened to my '11. Replaced and ended up putting on Grip n Rip brackets for next time. The weld won't hold on cast.
W
Might wanna think about getting the brace kit from grip n rip. Did it last year and believe there is a bracket for right where it broke, might give it a better fighting chance.
