S
getting my cranked trued. wondering if possible to take out crank from the bottom.
crank pull from bottom
- Thread starter switchyluke
- Start date
no you have to completely disassemble the engine to remove the crank
S
okay. just sucks cause i had the head re done. have to put new gaskets in again. thank you for the reply
no problem , the cylinder head o rings should be ok for for reuse
S
hope so and the cylinder gaskets u think i should swap or keep
V
Likely swap if they were glued in. I doubt the gaskets could be cleaned enough to get a uniform sealing surface again.
S
gaskets are textile arent they?
V
Can't say for sure, but I used a thin film of HondaBond on both sides of mine so they are a single use only.
S
liquid gasket where the cylinders attache to the base? or where the case splits?
V
I do it at both. The case halves for sure, but I do the base gaskets as well, as per Carl's cycle since it is one of their engines.
S
what bond do you use?
V
I use HondaBond but there are others that work very similar. The tube I bought I have used on 3 different engines and about to use it again. Little bit goes a long way.
Similar threads
