Remove Silber for trade in and now it’s kicking a red code

Coldestwinter1

Active member

Premium Member

Oct 8, 2014

172

31

28

43

New york

• Sep 25, 2017

• #1

Remove Silber for trade in and now it’s kicking a red code

I removed the turbo this weekend to put it on the new sled and when I started up the sled it fires and turns right off if I give a little throttle it’ll run but as soon as I let off it dies and the check engine light comes on throttle response switch I think is what it says any ideas what’s wrong?

 

R

roni87

Well-known member

Feb 11, 2011

513

213

43

I Falls, MN

• Sep 25, 2017

• #2

Is the throttle cable too tight? Gotta have some play in the flipper at idle.

 

Boston Racing

Well-known member

Lifetime Membership

Nov 26, 2007

3,490

1,628

113

Colorado Springs, CO

• Sep 25, 2017

• #3

Send me a PM and I will shoot you my cell number. Im sure its something simple.

 

Wheel House Motorsports

Well-known member

Lifetime Membership

Nov 27, 2007

29,933

5,968

113

34

SW MT

• Sep 26, 2017

• #4

Easy enough to end up twisting the cable routing some and causing it to increase tension, make sure there is throttle free play per oem spec. Loosen it up and it probably is whats wrong.

 

Coldestwinter1

Active member

Premium Member

Oct 8, 2014

172

31

28

43

New york

• Sep 26, 2017

• #5

I plan on getting back into it this weekend I’ll update you guys thanks for the response

 

Coldestwinter1

Active member

Premium Member

Oct 8, 2014

172

31

28

43

New york

• Sep 27, 2017

• #6

Yup it was the throttle cable all’s good now can’t wait to pickup the sled! Any suggestions on things I might should look at or maybe replace with the kit it’s got about 500 miles on it?