S
On the right side or mag side there is only 1 rubber expansion engine mount. It bolts to another cast aluminum engine mount which bolts to the stator housing. The 2 bolts that hold this mount on are grade 10.9. I dont know how its possible but I managed to snap both of these bolts off without cracking the casing or mount. I never hit anything at all I just figure its from torque from the BB 900 motor. Anyone break these before and what was thier fix? I will probably just put the same type bolts back in after I do the easy out thinger. The only other difference is that the mount I had in there was a homemade mount made out of a hockey puck. I started with putting an AC mount back in.