• Don't miss out on all the fun! Register on our forums to post and have added features! Membership levels include a FREE membership tier.

2006 xrs narrow A-arms

T
May 7, 2017
38
2
8
51
Would a rev summit A-arms work? Make it 37inch if I got the rest of the steering hardware for it. Thanks


Sent from my Z832 using Tapatalk
 
T
May 7, 2017
38
2
8
51
I'm new to the Revs been a zx guy till this year. Gonna try one out but can already tell its to wide.


Sent from my Z832 using Tapatalk
 

cubby

Well-known member
Premium Member
Nov 26, 2007
2,206
484
83
There are bushings on your skis, make sure they are at the narrowest spacing and the will help some.
 
T
May 7, 2017
38
2
8
51
It is an 2006 xrs not a xrs summit. Was thinking bout tring summit a arms on it to marrow up. Does A.I. have short tie rods also or will I have to get or make some. 36 ctr to ctr sounds real good to me.

Sent from my Z832 using Tapatalk
 

cubby

Well-known member
Premium Member
Nov 26, 2007
2,206
484
83
If it is a XRS then I believe it has to be an 07, it was the only year that I knew of skidoo making the XRS package. Also as far as I know all skidoo rev chassis sleds from 03.5 to 07 used the same A arms, but I might be mistaken on this.
 

alt

Well-known member
Lifetime Membership
Jan 7, 2010
902
638
93
Livingston
www.alternativeimpact.com
Sorry I didn't see this earlier. Basically the arms we have will fit anything from 2003-07. The summits are 39.5" and have the correct shock length for our 37" kit. The mxz is a 42.5" stock stance and again WILL work but the shocks would need shortened, normal cost of about $100ish plus shipping. Tie rods would need to be shortened on this particular kit. Thanks guys!
Dan
 
Last edited:
T
May 7, 2017
38
2
8
51
Sorry I didn't see this earlier. Basically the arms we have will fit anything from 2003-07. The summits are 39.5" and have the correct shock length for our 37" kit. The mxz is a 42.5" stock stance and again WILL work but the shocks would need shortened, normal cost of about $100ish plus shipping. Tie rods would need to be shortened on this particular kit. Thanks guys!
Dan
Thanks very much . I'll be ordering a set here in the near future.


Sent from my Z832 using Tapatalk
 
T
May 7, 2017
38
2
8
51
Must be a 2007 if it's the XRS Summit. Only way to get narrower arms is either to make them or buy from Alt. Impact. Dans narrow arms will get you a 36" center to center and designed to save the bulkhead on impact. They work well.
It is a 2007 summit xrs ,little more looking into it

Sent from my Z832 using Tapatalk
 
Premium Features