For support please email or pm Christopher

Upgrade to Premium
Northeast US Adirondacks, Old Forge, Tug Hill, Maine, Vermont, New York, etc,
Share Thread Tools Display Modes
Old 12-31-2017, 06:47 PM
600Fuse 600Fuse is offline
Currently: Not set.
Join Date: Dec 2017
Basic Member
Age: 26
Posts: 1
Thanks: 0
Thanked 0 Times in 0 Posts
Rep Power: 0
600Fuse is an unknown quantity at this point
Default 06 600 Fusion very hard to turn over

I am new to the forum and am not sure if I'm in the right thread but all help is appreciated.

Last week I went to pull my clutch off and was given the wrong puller. I did not know that until I looked deeper into it.
To start I ran the puller in and tapped it with a hammer. Clutch did not come off. I did this several several times. Afraid of damaging the crank I stopped. I then found the pullers threads weren't allowing the puller to touch the crank. I shaved some threads off and then tried it again. The clutch fell right off in my hand as it should.

I rebuilt the clutch and put it on my sled. Went to pull it over and the recoil wouldn't even budge. I pulled the recoil off thinking something my be frozen. That was not the case. I then tried to spin the clutch by hand and it was very very hard but it did spin. I pulled the plugs out and still very very hard. I pulled both crank case drain plugs and it's still very very hard.
I have heat in the shed but it does get to -20 at night. Creates condensation in the shed.
The snow is great here and I'm itching to ride. Any suggestions on what to do are greatly appreciated as I'm pulling my hair out trying to solve this.

Ps sled did run and drive multiple times before I took the clutch off. Fresh gas and oil. When the motor is spun over by hand, it does not sound like anything is binding or grinding. Just very very hard to spin by hand.
Reply With Quote

Rate this post: Yes | No


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Thread — How hard is your track to turn by hand? Thread Starter — 562xp Forum — Polaris: AXYS Replies — 67 Last Post — 01-06-2018 12:42 AM
Thread — Track hard to turn Thread Starter — damx Forum — Polaris: Pro-Ride Replies — 11 Last Post — 12-25-2013 10:58 AM
Thread — Hard to turn Ski's while riding? Thread Starter — sleded800 Forum — Polaris: Pro-Ride Replies — 36 Last Post — 03-28-2012 07:53 AM
Thread — 09 M8 shuts off when making hard turn to the right Thread Starter — troyburt Forum — Arctic Cat: M Series Replies — 4 Last Post — 02-17-2011 05:11 PM
Thread — 08 M1000 hard to turn? Thread Starter — biggdaddy Forum — Arctic Cat: M Series Replies — 10 Last Post — 01-03-2011 07:51 PM

All times are GMT -6. The time now is 09:32 AM.

no new posts