DPM Solenoid Valve

it's simple about 15 min or less. remove air box, disconnect the DPM, heat the top clear tube with a hair dryer (makes it easier to get off) rotate the DPM manifold so you can get to the screw i used a 5mm or 5.5mm wrench, there is a small piece of plastic and two o-rings on the solenoid Dont lose them!!!!! when removed spray end of the solenoid with WD-40 Use a paper clip to move the solenoid back and forth, it will only move about 1/16 to an 1/8 reinstall

hope this helps