2004 Firecat F7 Nightfire LE with factory EXT 144 kit. 3670 miles $4200
There were very few of this machine built. The entire hood, tunnel and skid were blacked out from the factory. Machine is currently located in Fargo but is on it's way to central Minnesota. Can be delivered to Iowa as well.
• New Motor including new pistons, rings, water pump, bearings with custom lightweight wrist pins
• Crankshaft rebuilt and trued. Cases measured and blueprinted.
• All new electrical components including stator, coil and wires, caps and plugs
•MSD low resistant wires and crimped caps
• Rear skid has been completely inspected with all new bearings and rebuilt shocks
• New front and rear suspension bushings and fresh grease
• Chassis has been completely disassembled, inspected and reassembled
• Throttle bodies have been synchronized, TPS calibrated to Cat specifications
• Clutches completely rebuilt to new condition and re-balanced
• Alignment and offset have been perfectly set
• Arctic Cat factory race track 144”x14”x2” reversible finger track
• Custom ArcticFx wrap
•SLP twin pipes with trail silencer
•Boondocker Box
•I also have two sets of SLP race pipes. One set cut for running higher RPM. One set ceramic coated
This machine has had about 1.5 hours on the new motor. Chassis and motor have been completely gone through from top to bottom and are in excellent condition. Please call 208-520-2042 and leave a message or email apexcarpetcleaning@rocketmail.com for questions.
There were very few of this machine built. The entire hood, tunnel and skid were blacked out from the factory. Machine is currently located in Fargo but is on it's way to central Minnesota. Can be delivered to Iowa as well.
• New Motor including new pistons, rings, water pump, bearings with custom lightweight wrist pins
• Crankshaft rebuilt and trued. Cases measured and blueprinted.
• All new electrical components including stator, coil and wires, caps and plugs
•MSD low resistant wires and crimped caps
• Rear skid has been completely inspected with all new bearings and rebuilt shocks
• New front and rear suspension bushings and fresh grease
• Chassis has been completely disassembled, inspected and reassembled
• Throttle bodies have been synchronized, TPS calibrated to Cat specifications
• Clutches completely rebuilt to new condition and re-balanced
• Alignment and offset have been perfectly set
• Arctic Cat factory race track 144”x14”x2” reversible finger track
• Custom ArcticFx wrap
•SLP twin pipes with trail silencer
•Boondocker Box
•I also have two sets of SLP race pipes. One set cut for running higher RPM. One set ceramic coated
This machine has had about 1.5 hours on the new motor. Chassis and motor have been completely gone through from top to bottom and are in excellent condition. Please call 208-520-2042 and leave a message or email apexcarpetcleaning@rocketmail.com for questions.
Last edited: