Where is the best place to tie in for power that is after the switch? Hooking up a display and need some power.
Post switch power on a nytro.
- Thread starter Tuesday
- Start date
G
Ive tied in at the 12V power point. this was a different application but it seem to only work when the motor was running. I also installed a 2nd inline fuse (7A for my application).
Ya, I think I will just tie into the power that runs the 12v adapter connection.
Z
I will use your picture to show you:
All the way to the right you can se a green fuseholder(or block). These wires are key on 12v +
//Tom
All the way to the right you can se a green fuseholder(or block). These wires are key on 12v +
//Tom
Thanks again zipper.
