P penny1l Free Member Jan 2, 2009 520 4 18 Dec 17, 2016 #1 Never looked at it yet but wonder if any one has directions or can explain the easiest was to get old track off and new track on Thanks guys
Never looked at it yet but wonder if any one has directions or can explain the easiest was to get old track off and new track on Thanks guys
C couch Free Member Nov 29, 2008 771 372 63 Dec 19, 2016 #2 Skid and motor comes out as a single unit then you can begin to swap out track.
V volcano buster Well-known member Nov 26, 2007 4,222 1,614 113 Stayton Oregon Dec 20, 2016 #3 I've done it without pulling the engine but not sure it was any easier.
P penny1l Free Member Jan 2, 2009 520 4 18 Dec 20, 2016 #4 How do you get the driver out ? I have the skid out now Thanks
V volcano buster Well-known member Nov 26, 2007 4,222 1,614 113 Stayton Oregon Dec 20, 2016 #5 The brake side has to come off which if I remember correctly allowed the drive shaft to slide over. I don't remember if there is a keeper on the secondary side or not. Too many years ago now.
The brake side has to come off which if I remember correctly allowed the drive shaft to slide over. I don't remember if there is a keeper on the secondary side or not. Too many years ago now.
P penny1l Free Member Jan 2, 2009 520 4 18 Dec 21, 2016 #6 I have complete brake side taken apart ??? :juggle:
8 84lxconvertible Free Member Aug 18, 2009 11 0 1 Dec 21, 2016 #7 http://www.snoscoot.com/sno-scoottechnicalinformation.html
8 84lxconvertible Free Member Aug 18, 2009 11 0 1 Dec 21, 2016 #8 http://www.snoscoot.com/sno-scoottechnicalinformation.html Lots of good info, just click on the track install instructions on the left of the page.
http://www.snoscoot.com/sno-scoottechnicalinformation.html Lots of good info, just click on the track install instructions on the left of the page.
