T
Brand new Crankshaft with used polaris 1200 (tripple watercraft cases) Yes this is ready for your cylinders. 750$ heck of a deal for a tripple 1200 bottom end.
Polaris 1050 1200 Bottom end NEW
- Thread starter Turbobusa
- Start date
snow crank or WC crank?
T
wc 1200
It has the pto end for a snomobile clutch. I will post some pics soon.
It has the pto end for a snomobile clutch. I will post some pics soon.
What else does a guy need to have?
I just pulled a twin out of my chassis.
I have p-85 primary and a GenII chassis.
RMK800 cdi and wire harness.
Engine plate for a BIG twin. Might fit a triple.
I have 800RMK ves pipes for twin. Just need another pipe and fitting I guess.
I need cyls and heads.
What else?
I just pulled a twin out of my chassis.
I have p-85 primary and a GenII chassis.
RMK800 cdi and wire harness.
Engine plate for a BIG twin. Might fit a triple.
I have 800RMK ves pipes for twin. Just need another pipe and fitting I guess.
I need cyls and heads.
What else?
If the cases are already machined out for the 800 cyls, you will still need...
Water rail for cases, cyls, heads, all internals (pistons rings etc), gaskets, the twin recoil waterpump and mag housing will work but isnt ideal, third pipe, manifold and silencer along with pipe fitment, tripple ignition setup (XCR, ultra, RXL with brads hub insert on the flywheel) brads motor plate, carbs, dual fuel pumps (dependant on carb application) some extra torque stops are good, gym membership for arm strength, balls, might have to address the front shocks/springs, misc nuts, bolts, hardware etc, double pass U cooler, extroverts, good chain/gears/bearings, solid bulkhead, the tq on these motors eat alot of those parts!
I think if you take a true WC crank and just add the PTO end for snow they seem to have balance problems with the higher RPM. Lynn or brad would know!
By far the best naturally asperated 2 stroke motor money can buy PERIOD!
Similar threads
