• Don't miss out on all the fun! Register on our forums to post and have added features! Membership levels include a FREE membership tier.

a must-do

sno*jet

Well-known member
Premium Member
Dec 13, 2007
2,820
1,283
113
20150319_231551_zpsqcyqleco.jpg


no pics of cutting off the aluminum trim, but just drill the rivets out from the tunnel roll and hack it off right before the hood strap. then drilled a couple holes and rivet the hood strap mount to the plastic. you can see two rivets on the side here.

20150320_142158_zps4eelnht3.jpg


much better for them sidehill maneuvers and riding the old iron like buradnt.
make sure you get some running board traction on the tunnel rolls! i use little hex head screws, drill a hole about every inch down the length, zip em in and done.
 
Last edited:

sno*jet

Well-known member
Premium Member
Dec 13, 2007
2,820
1,283
113
i think its an iq seat maybe i forget. 08ish era. i made a plastic platform to support it underneath, and yes, the stock gas tank supports the front part a bit.
 
Premium Features