C captcolby Member Lifetime Membership Oct 24, 2009 85 5 8 Seward, AK Oct 25, 2018 #1 Anyone know the part number for a clutch puller?
mountainhorse Well-known member Lifetime Membership Premium Member Dec 12, 2005 18,606 11,814 113 West Coast www.laketahoeconcours.com Oct 25, 2018 #2 I would just buy a 3/4"-16 x 3" fully threaded hex bolt from Fastenall etc.. and use the water method... more gentle on your crank. .
I would just buy a 3/4"-16 x 3" fully threaded hex bolt from Fastenall etc.. and use the water method... more gentle on your crank. .
C captcolby Member Lifetime Membership Oct 24, 2009 85 5 8 Seward, AK Oct 25, 2018 #3 Tip it on it's side fill with water and use teflon tape on the bolt?
mountainhorse Well-known member Lifetime Membership Premium Member Dec 12, 2005 18,606 11,814 113 West Coast www.laketahoeconcours.com Oct 25, 2018 #4 Yup. And I like to put a heavy wet bath towel around the clutch to contain it when it pops off. Murph leaves the belt on. .
Yup. And I like to put a heavy wet bath towel around the clutch to contain it when it pops off. Murph leaves the belt on. .