Not getting full throttle

S

sledhed88

Member

Dec 13, 2007

671

14

18

• Nov 26, 2008

• #1

2008 M-1000 Turbo

Im not gettin full throttle on this, its only opening about 3/4 - 7/8. To adjust the cable anymore, it creeps bad..

Is the cable stretched already?? Or am i missin something

 

S

sledhed88

Member

Dec 13, 2007

671

14

18

• Nov 27, 2008

• #2

Can anyone tell me if the throttle bodies are supposed to open 100% all the way??

 

S

Snowstar

Well-known member

Aug 22, 2006

1,069

58

48

Ogden Ut.

• Nov 27, 2008

• #3

The cable actuator should hit the full throttle stop on the throttle bodies at WOT.

 

S

sledhed88

Member

Dec 13, 2007

671

14

18

• Nov 27, 2008

• #4

I have to adjust the cable fully out to make it like that.. But then at idle it goes across the garage floor lol(no joke)

 

D

DWHalverson

Free Member

Oct 19, 2003

1,247

89

48

51

Rapid City, South Dakota

• Nov 27, 2008

• #5

Stock cable with no extension? Stock throttle block?

 

S

sledhed88

Member

Dec 13, 2007

671

14

18

• Nov 27, 2008

• #6

Yes to both.. Im gonna try something, but i dont think it will help.. Throw me ur ideas

 

P

Pilsner

New member

Dec 1, 2007

268

3

18

• Nov 27, 2008

• #7

Set your cable length so there is about .020" play at the blipper with the engine off. Adjust idle screw to get proper idle RPM 1800-2000.

 

S

sledhed88

Member

Dec 13, 2007

671

14

18

• Nov 27, 2008

• #8

Can someone give me the widest measurement off the stock handlebars?? Throttle side. Mine is 32.8mm close to the throttle with grips on..

I back the idle screw right off still bad, if i set the throttle bodies to open fully

 

P

Pilsner

New member

Dec 1, 2007

268

3

18

• Nov 27, 2008

• #9

I changed the throttle block on my sled this year and just adjusted the free play in the blipper to match the new throttle block. When I put the thumb to the bars I checked the tension on the t-cable at the blipper to see if I was getting full throttle. Worked fine for me, I'd check for something else causing the high idle.

What does it idle at when the cable is adjusted for full throttle?

 

S

sledhed88

Member

Dec 13, 2007

671

14

18

• Nov 28, 2008

• #10

I pulled the tach on it but it was pretty high.. Before i started messin wit this i put in a purple/whte primary spring, maybe i should put the other one back in fornow

 

S

sledhed88

Member

Dec 13, 2007

671

14

18

• Nov 28, 2008

• #11

changed the bars from stock to rsi carbon.. right about where the middle of the throttle flapper touches the bar, these are about a mm or two wider.

how much of an affect would this be

 

S

sledhed88

Member

Dec 13, 2007

671

14

18

• Nov 29, 2008

• #12

ttt