K
Parting out entire 2007 Yamaha Phazer MTX stock. Engine spun a rod bearing but looks like block is fine. Not sure on crank, I haven't tore engine down. 1308 miles when it let go.
Some parts have sold so just ask but still have 80% of it left. Tunnel, 144" rear skid, front end (A-arms, tie rods), frame, secondary clutch, full electrical harness with ECU (NOT CUT OR HACKED UP), handle bars, entire brake system, steering system, some plastics, full cooling system, oil tank, full exhaust, head with cams, cooler, forward/reverse gear case with jackshaft and servo, throttle bodies, fuel pump, chain case with gears chain, upper and lower frames, etc. Lots available.
Sold items......
Seat, gas tank, seat frame, front shocks, track, all white plastics, windshield, front bumper, primary clutch, rear skid torsion springs, ignition coil caps, skis, Roll over valve/tether, right and left spindles, windshield bag,
All parts are make an offer + shipping.
Some parts have sold so just ask but still have 80% of it left. Tunnel, 144" rear skid, front end (A-arms, tie rods), frame, secondary clutch, full electrical harness with ECU (NOT CUT OR HACKED UP), handle bars, entire brake system, steering system, some plastics, full cooling system, oil tank, full exhaust, head with cams, cooler, forward/reverse gear case with jackshaft and servo, throttle bodies, fuel pump, chain case with gears chain, upper and lower frames, etc. Lots available.
Sold items......
Seat, gas tank, seat frame, front shocks, track, all white plastics, windshield, front bumper, primary clutch, rear skid torsion springs, ignition coil caps, skis, Roll over valve/tether, right and left spindles, windshield bag,
All parts are make an offer + shipping.
Last edited:
