B
2006 900. Just pulled the engine again to replace 2 more injectors and found that all 4 Motor mounts are shot! Replaced them last year and really havent ridden it hard at all. Still not running right and I dont think these have more than 100 miles on them. I did put in SLP torque arm and mag side bumper (cant remember the name right now). When i put the engine back in last time everything seemed to line up just fine. adjusted the torque rod so that it would easily bolt up.
motor has a TM1 crank and indy dan clutch that was done last engine pull. I did put red locktite on all the bolts and used an impact wrench to take out the rear motor mount bolts.
Im pretty sure I bought polaris mounts last time. Just ordered some new ones.
Any ideas why these didnt last very long? could it be from the surging that I still havent gotten rid of? Or am I doing something wrong when I put it back in?
Im hoping to get this thing running someday!
motor has a TM1 crank and indy dan clutch that was done last engine pull. I did put red locktite on all the bolts and used an impact wrench to take out the rear motor mount bolts.
Im pretty sure I bought polaris mounts last time. Just ordered some new ones.
Any ideas why these didnt last very long? could it be from the surging that I still havent gotten rid of? Or am I doing something wrong when I put it back in?
Im hoping to get this thing running someday!