01 mm 600

N

nytroryder

Free Member

Sep 4, 2009

21

1

3

Palmer AK

• Jan 26, 2010

• #1

so i just picked up a 01 mm 600. this thing is completely stock and only has 1900 miles. I was wondering any one would recommend for jet size to run.
mostly will be run around 2-4000 feet. I used ride to 700s and alway jetted down. I am just not sure how far down i go with the 600.

Thank you

 

S

sagerider

Free Member

Feb 1, 2009

75

5

8

Baker, Oregon

• Jan 26, 2010

• #2

Jetting

Stock set-up is: 1,600 to 3,300 ft at 0 F

Main Jet
Cyl No. 1 136.3 135.0
Cyl 2,3 133.8 132.5
Pilot
6DHN50/3 42.5
Needle Jet
No 1 Q-4 clip 2.5
No 2,3 Q-2
Pilot Air Screw
2 turns out

Cyl No.1 is PTO

From Clymer Manual

 

S

sagerider

Free Member

Feb 1, 2009

75

5

8

Baker, Oregon

• Jan 26, 2010

• #3

Hmm... sorry, tabbing/spacing didn't turn out right.

1,600 - 3,300 at 0 F

No1 PTO 135.0
NO 2 and 3 132.5
clip 2.5
PILOT 42.5

 

S

snowdad4

Free Member

Nov 26, 2007

341

36

28

southeast washington state

• Jan 26, 2010

• #4

or 3300-5000 @20*F #1mj, 133.8, #2,3 131.3. pj42.5, needle at 2.5, fuel screw 2.5 turns out.

 

N

nytroryder

Free Member

Sep 4, 2009

21

1

3

Palmer AK

• Jan 26, 2010

• #5

Thank you

 

TRIPLESWILLNEVERDIE!

Well-known member

Lifetime Membership

Feb 19, 2008

526

74

28

Northwest, MT

• Jan 26, 2010

• #6

Yea, what snowdad4 said will get you very close.
If it is boggy when you mash the throttle from a standing start you will also need to go to the .08 air jets. You might be just fine if your running the stock can though.