• Don't miss out on all the fun! Register on our forums to post and have added features! Membership levels include a FREE membership tier.

Home made/custom trailing arms

C

Clarke673

Somewhere between too dumb to quit and flat earth
Dec 2, 2007
3,138
483
83
Gardiner Montana
Anyone get ballsy and build their own? messing around with a 2001 SRX700. Drop and roll, elka tunnel, 151" finger track. Probably going to swap to a 153 attack 20.

Was looking at raising the front end up a bit in doing this mod. Don't feal like spending big bucks on alternative impact or similar products.
 

motojunkie101

MODERATOR: Premium Member
Staff member
Premium Member
Nov 26, 2007
2,281
805
113
40
Sandpoint, Idaho
I've seen home brew arms made out of tube, but it was a long time ago. I don't think it would be too hard as long as you get the angles correct.
 

Ford428CJ

Well-known member
Lifetime Membership
Jan 16, 2009
380
52
28
Klamath Falls, Oregon
IMG_2328.jpg

IMG_3555.jpg

IMG_3570.jpg

I just raised my front end on my 700MM a good 2". I also put in a M 162" skid and track. I also have a custom extended chain case. So I have a 3" pitch 8 tooth driver. I can run a 3" paddle easy now
 
C

Clarke673

Somewhere between too dumb to quit and flat earth
Dec 2, 2007
3,138
483
83
Gardiner Montana
I was doing some research and ran into some of your older posts.

At this point I may just order a bunch of meterial and do some new ones. Just been tinkering with this think and can't get the front suspension to make me happy. The answer is clearly to start over!:eyebrows:
 
Premium Features