• Don't miss out on all the fun! Register on our forums to post and have added features! Membership levels include a FREE membership tier.

Roll-Over Valve kits for Proclimb M1100 from Four Stroke Solutions LLC

MTN_VIPER

Well-known member
Lifetime Membership
Nov 26, 2007
976
436
63
NW WA St.
fourstrokesolutionsllc.com
im wanting to make my harness longer to be able to route wires better than what it is. will I have problems splicing wires into it? as long as I get all the wires hooked back up to the correct ones I should be fine im thinking.

thanks

Yes, you can add length to any of the wires without issues, as long as the correct color/position is maintained along with wire gauge. For splicing in, I prefer to use shrink/seal butt connectors that have the adhesive melt liner. When heated the sleeve of the connector shrinks to the wire to seal out moisture. http://www.waytekwire.com/products/1425/Butt-Connectors/&Insulation-Material=Heat-Shrink

I try to add in a little bit of extra length, however some installations may vary due to owner preference and sled mods etc.

Bill
 
Premium Features