S
My sled lost power for a few seconds and then just died. There is no spark whatsoever. I bypassed killswitch and throttle safety switch, no spark. I also pulled out the main wiring harness from the ecu and still no spark. I then tested resistance on stator coils, charge coil#1 has 44,4 ohms (way too high) and #2 has nothing. All other stator coils are fine. I assuming this is telling me that my stator is cooked?
Now the other thing is that I tested my ignition coils. One of them was at 44000 ohms and the 3 other were at 10000 when they are all suposed to be around 6300 ohms. Could my charge coils have cooked my ignition coils? or vice versa?
I figure at this point I should probably change the stator and see how it goes afterward, make any sense?
Now the other thing is that I tested my ignition coils. One of them was at 44000 ohms and the 3 other were at 10000 when they are all suposed to be around 6300 ohms. Could my charge coils have cooked my ignition coils? or vice versa?
I figure at this point I should probably change the stator and see how it goes afterward, make any sense?
