H
I am installing a RACEPAK Avenger II EGT/Temp/RPM gauge on my 05 Summit REV 800 and I am having trouble finding the right wire to tie into to get a tach pulse. All accessory, lighting and instrumentation power is provided by one wire which goes thru the relay and than splits and goes thru 2 fuses. One is for the headlights and the other is for everything else. This line is regulated and does not provide a pulse signal that can be used to trigger the tach.
There is a wire that comes directly off of the Magneto and goes directly to the Speedometer connector but isn't labed as to what is for. I assume this is the trigger for the Tachometer. Does anyone know for sure. If so, is this the correct wire to tap into to get my RPM input for my Avenger II?
I am positive that there are many folks out there that use or have at one point used a RACEPAK gauge and can tell me were to hook this too.
Thanks in advance...
There is a wire that comes directly off of the Magneto and goes directly to the Speedometer connector but isn't labed as to what is for. I assume this is the trigger for the Tachometer. Does anyone know for sure. If so, is this the correct wire to tap into to get my RPM input for my Avenger II?
I am positive that there are many folks out there that use or have at one point used a RACEPAK gauge and can tell me were to hook this too.
Thanks in advance...