So I had to change out my grip heaters. In doing so, I changed out
my grips. I do not like the latest grips from Cat. Too thin, too slick. I just prefer a thicker grip and went with ODI. So, I put down 1/16 padded type of an insulation on the bar, then to firm it up a bit, I used a small layer of electrical tape. Then the new heaters and then the new grips. Its feels very good in my hand but it is definitely thicker. Do I need to be concerned about not getting full throttle? I don’t think I’ve ever felt like I need to cram the flipper through the bar to get a little more. Are there adjustments I can make if I took some full throttle away?
Sent from my iPad using Tapatalk
my grips. I do not like the latest grips from Cat. Too thin, too slick. I just prefer a thicker grip and went with ODI. So, I put down 1/16 padded type of an insulation on the bar, then to firm it up a bit, I used a small layer of electrical tape. Then the new heaters and then the new grips. Its feels very good in my hand but it is definitely thicker. Do I need to be concerned about not getting full throttle? I don’t think I’ve ever felt like I need to cram the flipper through the bar to get a little more. Are there adjustments I can make if I took some full throttle away?
Sent from my iPad using Tapatalk