Removing jackshaft

1

1Mike900

Well-known member

Premium Member

Dec 5, 2007

996

169

43

Bellevue, Wa

• Dec 9, 2017

• #1

Been looking thru the old threads, but couldn't find anything? I would assume to remove the jackshaft one would need to remove carbs/airbox etc... Question is does the aluminum shaft cover need to be removed to get it out? Does the bellypan need to be removed also? I have vent holes drilled in bellypan in that area almost dead inline. Could I slide it straight out, or do you lift over?

Thanks Mike

 

D

Dobber1

Well-known member

Nov 26, 2007

3,836

784

113

Colorado

• Dec 21, 2017

• #2

Give this a shot...should be similar?
https://youtu.be/oTaCz1HujOg

 

T

tmaiwa

Free Member

Mar 5, 2008

75

9

8

• Dec 25, 2017

• #3

shaft

Don't need to remove carbs or nothing. Remove chain cover, take off lower gear, 3 nuts behind gear that hold bearing cover in place same thing on clutch side. I remove secondary to give more room, 3 nuts on that side too. Shaft will come out. Of course, must loosen the track.

 

1

1Mike900

Well-known member

Premium Member

Dec 5, 2007

996

169

43

Bellevue, Wa

• Jan 28, 2018

• #4

I was talking jackshaft, you are referencing drive shaft I believe?

 

D

deanross

Well-known member

Lifetime Membership

Nov 29, 2010

370

205

43

Cody WY

• Jan 28, 2018

• #5

You tube does have several jack shaft removal videos. Not sure if any for your specific sled or not?