Our jackshaft for the 2016-2016 ProClimb is not only 2 lbs lighter than stock but its also stronger than stock. It is a direct replacement for the stock one, but also is threaded on the end for more strength when installing a belt drive. The bolt and machined washer will hole the top sprocket firmly against the shaft. The stock snap rings can allow the top belt drive sprockets to wobble, wear out the spline, and cause premature belt failure. So using this shaft has several benefits.
In the picture, the larger diameter version is our version. The fit the 6000 and 8000 models. And we do have a limited number of Reverse models versions for the 5000, 7000, and 9000 models.
The picture with the three shaft ends shows the end of the reverse model too.
http://www.bd-xtreme.com/index.php?..._shop=1&id_employee=3&theme=&theme_font=font7
In the picture, the larger diameter version is our version. The fit the 6000 and 8000 models. And we do have a limited number of Reverse models versions for the 5000, 7000, and 9000 models.
The picture with the three shaft ends shows the end of the reverse model too.
http://www.bd-xtreme.com/index.php?..._shop=1&id_employee=3&theme=&theme_font=font7
Last edited:
