Did this ever get figured out, I cannot find the info anywhere, on an 07 M1000 where is the tach/power supposed to hook up? I went to the yellow lighting wire and everything works fine but the tach doesn't work correctly at high rpm. It is accurate at idle, but peaks at 5400. I went through and adjusted calibration 4-5 times, it is correct as at every other setting, idle is not right. SIgnal must get confused at high rpm?
Digatron M1000 Tach Install
- Thread starter Devilmanak
- Start date
It is a DC voltage system and must be the same as an Avenger 3 Racepack and needs a MSD signal modifier. Ran into this with my 2007 m1000 and everyone told me to call Summit and order an MSD Tach signal modifier and it will work fine then?? This is what I was told.:face-icon-small-ton
Similar threads
